onasti KXJTD003 Manuel D'utilisation page 4

Step 1:
Install C on the inner side of
panels A and B.
Insert G and H into the
corresponding holes of A,
and tighten with I.
F
EN EN
Step 2:
Insert D, E, and F into the
corresponding holes of A and
tighten with I
F
Step 3:
Fit panel B and tighten all
screws with J.
Press plate F down so that
both ends snap into the
grooves.
Put on K on each foot.
Step 1:
Lift D plate.
Step 2:
Lift F plate a little bit.
Warm reminder:
The lifting height of F should
be lower than the bottom of
C, otherwise, it will affect the
folding.
Step 3:
Fold the legs.
EN EN