Télécharger Imprimer la page

Outsider LOOP CORNER 171 Instructions De Montage page 6

Publicité

#171 LOOP CORNER - MOUNTING
B4 ASSEMBLY BRACKET
SAMLEBESLAG/MONTAGEHALTERUNG/
SOPORTE DE MONTAJE/SUPPORT DE MONTAGE
B4
Ø12mm
80mm
220mm
X
out-sider a/s
info@out-sider.dk
Kigkurren 8A, Islands Brygge
www.out-sider.dk
DK-2300 Copenhagen S
GB
The assembly bracket (B4) function as a spacer between the ends of two Loop Corner. The
bracket is adjustable (0-50mm).
Each bracket is mounted onto the bottom of each Loop Corner with the supplied M10x12
bolts.
DK
Modulerne samles med justerbart (0-50mm) samlingsbeslag (B4) i hver ende.
Hvert beslag monteres i bunden af hver Loop Corner med de
inkluderede M10x12 bolte.
DE
M10 x 12
Die Montagewinkel (B4) dienen als Abstandshalter zwischen den Enden der beiden Loop
Corner. Die Halterung ist verstellbar (0-50 mm).
Jede Halterung wird mit den mitgelieferten M10x12-Schrauben an der Unterseite jeder
Loop-Ecke montiert.
ES
El soporte de montaje (B4) funciona como espaciador entre los
extremos de dos Esquina de bucle. El soporte es ajustable (0-50 mm).
Cada soporte se monta en la parte inferior de cada Loop Corner con los pernos M10x12
suministrados.
FR
Le support d'assemblage (B4) fonctionne comme une entretoise entre les extrémités de
deux Arc de boucle. Le support est réglable (0-50 mm).
Chaque support est monté au bas de chaque Loop Arc avec les boulons M10x12 fournis.
NOTE! Hold the two modules close together when the bolts at the bottom are tightened.
BEMÆRK! Hold de to moduler tæt sammen, når boltene i bunden spændes.
NOTIZ! Halten Sie die beiden fest Module schließen zusammen, wenn die Schrauben an der
unten sind verschärft.
¡NOTA! Mantenga los dos Los módulos se cierran entre sí cuando los pernos en la abajo son
apretado.
NOTE! Tenez les deux modules se rapprochent lorsque les boulons au niveau en bas sont
resserré.
ü
01.08.2024
06

Publicité

loading

Produits Connexes pour Outsider LOOP CORNER 171