SOLAC PROMIXTER 2000W INOX Mode D'emploi page 7

• Put the measuring cup in the lid.
• Connect the appliance to the mains.
• Choose desired speed and start blending.
• To avoid a fierce start up, it is advisable to start off from
the lowest speed position and, once the appliance has
been switched on, progressively increase the speed to
the desired position.
• If you wish to add more ingredients pull out the measuring
cup. Add the ingredients and replace the measuring cup.
• To stop the appliance set the speed back to "0".
ELECTRONIC SPEED CONTROL
• The speed of the appliance can be regulated by using the
speed selector knob (F). This function is very useful, as it
makes it possible to adapt the speed of the appliance to
the type of work that needs to be done.
ONCE YOU HAVE FINISHED USING THE APPLIANCE
• Stop the appliance, selecting position 0 on the speed
selector knob.
• Unplug the appliance from the mains.
• Lift the jar from the motor body.
• Allow to cool down.
• Clean the appliance.
"PULSE / ICE CRUSH" FUNCTION
• The appliance works in highest speed to achieve optimal
performance.
• Turn the speed selector control anticlockwise and hold it
to operate. Release to stop operation.
• This function gives optimal result for ice-crushing, up to
desired snowy level.
• We recommend that you press and hold the button for 3
seconds at a time until you obtain the desired result.
CARRY HANDLE/S
• This appliance have a handles on the side of the body for
easy transport.
SAFETY THERMAL PROTECTOR
• The appliance has a safety device, which protects the
appliance from overheating.
• If the appliance turns itself off and does not switch itself
on again, disconnect it from the mains supply, and wait
for approximately 15 minutes before reconnecting. If the
machine does not start again seek authorised technical
assistance.
CLEANING
• Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
• Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
• Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
• Do not let water or any other liquid get into the air vents to
avoid damage to the inner parts of the appliance.
• Never immerse the appliance in water or any other liquid
or place it under running water.
• During the cleaning process, take special care with the
blades, as they are very sharp.
• It is advisable to clean the appliance regularly and
remove any food remains.
• If the appliance is not in good condition of cleanliness, its
surface may degrade and inexorably affect the duration
of the appliance's useful life and could become unsafe
to use.
• The following pieces may be washed in a dishwasher
(using a soft cleaning program) or soapy hot water:
- Jar
- Jar lid
- Measuring cup
- Blade set.
- Blade sealing ring
- Blade fixing ring
- Base ring
• The draining/drying position of the articles washable in
the dishwasher or in the sink must allow the water to drain
away easily
• Then dry all parts before its assembly and storage.
REMOVABLE BLADES FOR EFFECTIVE CLEANING
• To clean the blades, loosen the blade fixing ring by
turning it counterclockwise, remove it and remove the
blades for cleaning. (Fig.1)
• To reassemble, follow these steps in reverse order.