Watkins Wellness FreshWater Salt System Instructions D'installation page 2

Disconnect Power to spa
before opening the Control
Box to prevent possible
electrocution.
2. Open Control Box.
3. Insert the FreshWater Salt System Controller
wire into the RS485 communication terminal in
the Control Box.
4. Replace Control Box cover.
FreshWater
®
Salt System
5. Connect Controller Wire
• Connect Controller Wire to the Cartridge
Housing terminals located on the back of
the housing.
• Some models may have the Cartridge
Housing located away from the equipment
compartment. These models will have a
Cartridge Housing wire extension tube
located in the equipment compartment.
• Connect the Controller Wire to the wire
inside the extension tube.
CONTROLLER WIRES
CONTROLLER WIRES
EXTENSION TUBE
Page 2