SCULPFUN iCube-3W Manuel D'utilisation page 15

iCube Machine User Manual iCube Machine User Manual
6、
If you cannot use the
switch machine modes.
① Connect the machine to the computer via a USB cable, open the LightBurn, enter the appropriate command at the
command line to switch to the corresponding mode. The specific commands for the three modes are as follows:
AP Mode Command:
The machine will automatically transmit WiFi, connecting according to the
STA Mode:
$50=2 - Switching STA
$53=WiFi - Change WiFi to your own WiFi name
$54=passwd - Change the passwd to your own WiFi password. Note that the password can not contain symbols, only
a combination of numbers and letters of the alphabet. GRBL Limitation.
BT Mode: $50=3
After the switch is complete, the engraver will turn into BT mode. Use the computer to match the BT to use the
LightBurn.
13
Sculpfun Laser Tool configuration tool, please refer to the command line method to
$50=1
Mode(WIFI Mode,APP Connection Method 2)
APP Connection Method 1.