Installation Procedure; Installing The Camera; Configuring The Camera - Eminent Ewent EW1089 R4 Mode D'emploi

2.0 Installation procedure

Follow the steps below to install the camera on your computer.

2.1 Installing the camera

Note! It is not necessary to install this camera! This camera also works without
software installation.
1. Ensure your computer is powered on, and Windows has started.
2. Connect the camera to an unused USB port of your computer.
3. Windows will detect new hardware and install it.
4. Insert the supplied installation CD-rom in the CD-rom drive or DVD drive of your
computer.
5. Select the preferred language.
6. Click 'Next'.
7. Select 'Install Software'.
8. Click 'Next'.
9. Follow the instructions as shown on your screen to finish the installation.
10. Congratulations, your camera is now installed!
Attention! When you install on Windows XP, a 'Windows logo test' warning may
appear. Click 'Continue anyway' to continue the installation procedure.

2.2 Configuring the camera

1. Click 'Start'.
2. Click 'Programs' or 'All programs'.
3. Click 'Eminent', 'EW1089 iCam'.
4. Click 'AMCAP' to start the camera software.
Note: If you do not immediately see a picture you need to click 'Devices' in the menu
bar and see if the camera is present. Make sure the camera is selected.
5. Click 'Options' in the menu bar.
6. Click 'Video Capture Pin'.
7. Select the preferred 'Frame-rate'. Frame rate is the number of frames (pictures)
the camera shows every second. The maximum frame rate is 30.000.
8. Select the preferred 'Output Size'. The output size is the screen resolution as
shown on your monitor. The higher the resolution, the larger the camera image
will be in size.
9. Click 'Apply'.
10. Click 'Ok'.
11. Click 'Options' in the menu bar.
12. Click 'Video Capture Filter'.
13. Select the preferred contrast and brightness.
9 |
ENGLISH