What's In The Box; Dipswitches - Risco Rw132Xwr Instructions D'installation

1. Introduction
The 2-way wireless repeater increases the range between RISCO's 2-Way wireless
devices registered to the control panels, Agility, WiComm Pro, LightSYS Plus and
LightSYS Air. The repeater receives messages from wireless devices that were assigned
to it and resends these messages to a control panel. A repeater can be registered to the
control panel with 32 zones (including up to 8 PIR/Beyond CAMs), 3 sirens, 3 keypads,
8 keyfobs and one I/O expander. Up to 4 repeaters can be included per control panel.

What's in the Box

• 2-Way Wireless Repeater
• Power supply
NOTE: Keyfobs can operate with all repeaters including panels and consequently
should not be assigned to a specific repeater.

2. Dipswitches

Configuring the DIP Switch
Table 1
DIP SW Description
1 Battery Status LED
ON:* Battery status LED is enabled
OFF: Battery status LED is disabled
2 Top Tamper Bypass:
ON: Front cover tamper bypassed
Red LED ON: Battery charging
Red LED OFF: Discharging state or charging problem
3