Publicité
needs to place the glass plate for at least 20 minutes, and then
put it into the water to avoid cracking.
19. Group 2 Class B appliance
Group 2 ISM equipment: group 2 contains all ISM equipment in
which radio-frequency energy is intentionally generated and/or
used in the form of electromagnetic radiation for the treatment
of material, and EDM and arc welding equipment.
Class B equipment is equipment suitable for use in domestic
establishments and in establishments directly connected to a
low voltage power supply network which supplies buildings
used for domestic purposes.
20. This product internal light source LED light on < 60lm
in or the appliance end the work, the product automatically falls into
standby mode, and the product indicates the information of time
standby power＜ 0.8W.
.INSTALLATION...
1. Take out all the packing. If there is a safe film over the oven,
tear it off before use. Check carefully for damage. If any,
immediately notify dealer or send to the manufacturer's service
center.
2. Microwave
non-corrosiveness environments, kept away from heat and
humidity, such as gas burner or water tank.
3. To ensure sufficient ventilation, the distance of the back of
microwave to the wall should be at least 10 cm, the side to the
wall should be at least 5 cm, the free distance above the top
surface at least 20 cm. the distance of the microwave to the
ground should be at least 85 cm.
4. The position of the oven shall be such that it is far from the TV,
Radio or antenna as picture disturbance, or noise may occur.
The distance should be more than 5m.
5. The appliance must be positioned so that the plug is accessible,
and must ensure a good grounding in case leakage, ground
loop can be formed to avoid electric shock.
......................................................... ............
ovens
must
be
placed
26
After plug
.
under
dry
and
Publicité
