Renkforce DA-2311 Mode D'emploi page 21

• Entry of the ID in the receiver system:
To enter a radio remote control or a keypad in the receiver system, proceed as follows:
1) Push and hold the LEARN button of the receiver unit for one second until the
remote control LED lights up. (The button is recessed on the device; push it, e.g.
with a ballpoint pen.)
2) The receiver is now in "LEARNING" mode for 10 seconds and experts a valid ID
signal from the wireless keypad or the radio remote control key.
3) Push a button on the desired transmitter to be taught to the receiver unit as ac-
cess device once within these 10 seconds.
4) The remote control LED goes out when the code has been added.
5) Repeat the process for further wireless keypads and/or radio remote controls.
Delete entries from the receiver system
•
When a radio remote control key or wireless keypad is lost, the entire system must
be reprogrammed. For this, first delete all devices from the memory and enter the
desired transmitters again as described above.
To delete ALL device IDs from the memory, proceed as follows:
1) Push and hold the LEARN button for approx. 8 seconds until the remote control LED
flashes 2x. The flashing of the LED indicates that ALL IDs have been removed from
the memory.
2) To enter new wireless keypads or radio keys into the system, repeat the procedure
"Entry of an ID in the receiver system".
Operation of the system with a wireless keypad or a radio key
•
The system can be operated as follows with a wireless keypad or a radio key.
Operation by radio key:
1) To activate signal output 1, push button A.
2) To activate signal output 2, push button B.
3) To activate signal output 3, push button C.
4) To activate the doorbell, push button D.
Operation by wireless keypad:
1) Enter a user code of group 1 to activate signal output 1.
2) Enter a user code of group 2 to activate signal output 2.
3) Enter a user code of group 3 to activate signal output 3.
4) Push the doorbell button to activate the output for the doorbell.
21