Autotek TransAm TA 1800 Mode D'emploi page 8

Please read the user's manual carefully before the installation and the first operation
of the amplifier.
SPECIFICATIONS
Output Power RMS
Output Power Max.
Loudspeaker impedance (stereo)
Frequency Response
Total Harmonic Distortion
Signal-to-Noise Ratio
Input Sensitivity
Input Impedance
Low Pass Filter
Subsonic Filter
Phase Shift
Bass EQ
Line Outputs
Operating Voltage
Fuse Rating
Dimensions (B x H x L)
All Specifications are subject to change
WARRANTY
This product meets the current EU minimum warranty requirements, if purchased in countries of the EU. To en-
sure your warranty policy keep your original receipt proofing the date of purchase. Any damage to the product
as a result of misuse, abuse, accident, incorrect wiring, improper installation, alteration of date code or barcode
labels, revolution, natural disaster, or any sneaky stuff because someone messed up, repair or alteration out
side of our factory or authorized service centers and any thing else you have done that you should not have
done is not covered. This warranty is limited to defective parts and specifically excludes any incidental or con-
sequential damages connected therewith.
8
TA1800
1 x 400 W @ 4 Ohms
1 x 600 W @ 2 Ohms
1 x 800 W @ 1 Ohms
1 x 800 W @ 4 Ohms
1 x 1200 W @ 2 Ohms
1 x 1600 W @ 1 Ohms
1 – 8 Ohms
20 – 250 Hz (-3 dB)
< 0,1 % (80 Hz)
> 90 dB
0,2 – 2 V (High)
2 – 8 V (Low)
47 kOhms
30 – 250 Hz @ 12 dB/Octave
20 – 50 Hz @ 12 dB/Octave
0 - 180°
0 –18 dB @ 45 Hz
Stereo, fullrange
+12 V (9 – 15 V), negative ground
2 x 40 A
223 x 63 x 320/346 mm