Placing In Operation; Equipotential Bonding; Items Supplied - Weller COOPER Hand Tools HAP 1 Manuel D'utilisation

Description
100 W hot air soldering tool with integrated finger switch, suitable for soldering and desol-
dering surface mounted components. A wide range of nozzles makes the tool of universal
application.
The air flow is controlled using the finger switch integrated in the handle. The hot air flo-
wing out of the soldering tool is free of static charges. Hose and handle are of anti-static
design. The temperature-regulated hot air can be set to between 50°C and 550°C using the
control unit employed.
Technical Data:
Heater rating: 100 W
Heater voltage: 24 V AC
Max. air flow rate: 10 l / min.
Temperature range: 50°C – 550°C
Precision: +/- 30 °C

Placing in Operation

Ensure that the control unit is switched off. Place the hot air pencil in the safety stand. Plug
the electrical connector into the 7-pole connecting socket on the control unit and lock. Slide
the hose onto the „AIR" nipple on the control unit. Switch on unit and set temperature and
air flow rate.
Attention: Do not point the hot air soldering tool at persons or flammable objects.
Always place the hot air soldering tool in the safety stand when not in use.

Equipotential Bonding

The hot air soldering tool is equipped with an equipotential bonding wire that can be con-
figured as per the operating instructions for the control unit used.
Soldering Notes
GB
The hot air nozzles are screwed into the heater element. To change the nozzle use the 8 AF
socket spanner and lock the heater element using open-ended spanner.
Attention: The thread depth is max. 5 mm (0.2"). A longer thread will cause
irreparable damage to the heater element
Attention: In case of usage of nitrogen, ensure adequate ventilation (Only on units
with external compressed air supply)
Replacement hot air tools are supplied adjusted and can be connected without further
adjustment.
To check the temperature of the hot air, it is recommended to use a special measuring
nozzle (0058727808) through which a sheathed thermocouple ø 0.5mm can be connected.
Attention: For usage other than that given in the operating instructions as
well as unauthorised modification, no liability is accepted by the
manufacturer.
Attention: Do not work on live parts. (Anti-static plastics reduce the insulation cha-
racteristics)
Attention: The operating instructions for the control unit used are also
applicable in addition to these operating instructions

Items Supplied

Hot Gas Pencil 5 27 115 99
KH-holder 5 15 027 99
Nozzle 1,2 mm ø 5 87 270 59
Socket spanner SW8 5 87 488 61
Subject to technical change without notice!
4