Publicité
Les langues disponibles
Les langues disponibles
Maintenance
Grease the drives in the drive housings and the moving parts at
least four times a year, or more often in the case of intensive use.
To grease the drives, take out the 2 screws and open the covers of
the housings.
To grease the threaded rods, open the filling cap located on the
tubes.
Installation
• The vehicle must have the hand brake off and be in neutral. It
must be on a horizontal surface so that it does not roll because
of its own weight.
• Place the Mini Lift at the side of the vehicle. The drive housings
must be placed towards the front of the vehicle.
• Slide the Mini Lift under the vehicle, until it is centred with the
longitudinal axis of the vehicle. Adjust the distance between
the runners to fit the width of the vehicle. The two rubberised
runners must be symmetrical in relation to the bottom of the car
body. Check that the runners are not in contact with any fragile
component of the vehicle.
• To Iift the front of the vehicle, place the drive housings in
contact with the front wheels of the vehicle (for front-engine
vehicles).
– 24 –
Publicité
