XGIMI MoGo 2 Plus Guide De L'utilisateur page 8

FCC Warning
The device meets the provisions of part 15 of the FCC Rules. The device
meets the following 2 conditions:
(1) The device will not cause harmful interference.
(2) The device must accept any interference received, including interference
that may result in unintended operations. The product's user guide or
operating instructions must remind users that intentional or unintentional
modification and replacement of transmi ers without explicit approval from
the responsible compliance party may prevent the user from operating the
device. If the user guide is provided in a form other than paper, such as,
provided in a computer disk or through the Internet, the information required
in that section can be included in the user guide in the alternative form under
the premise that users have access to the alternative form.
For B-class digital or peripheral devices, instructions provided to users must
include the following or similar statements and be placed in a prominent place
of the user guide:
The device has been tested to meet the restrictions of part 15 of the FCC Rules for B-class
digital devices. These restrictions are aimed at providing the e ective prevention of harmful
interference in a residential installation. If installation and use are not performed according to
the instructions, the device will generate and radiate radio frequency energy, and may cause
harmful interference to radio communication. However, there is no guarantee that
interference will not occur in a particular installation. If the device does cause harmful
interference to radio or television reception (determined by stopping and starting the
device), it is suggested that users a empt to correct the interference through one or more of
the following measures:
- Reposition the direction of the receiving antenna.
- Increase the distance between the device and the receiver.
- Connect the device into an outlet on a circuit di erent from that to which the receiver is
connected.
- Consult distributors or experienced radio/television technicians to seek help.
- This device is acting as a subordinate device and operating in the 2.4 GHz
(2.402-2.480 GHz, 2.412-2.462 GHz) band or 5 GHz (5.180-5.240 GHz, 5.260-5.320 GHz,
5.500-5.700 GHz, 5.745-5.825 GHz) band.
Disposal instructions for used products:
This product is designed and manufactured with high
quality materials and components that are recyclable.
* Only use a achments and accessories specified or provided by the manufacturer
(such as the dedicated power supply adapter).
* This product may emit harmful light radiation.
Warning
1. Adapter shall be installed near the equipment and
shall be easily accessible.
2. The device complies with RF specifications when it is
used at a distance of 20 cm away from your body.
3. To prevent possible damage to hearing, do not listen
at high volume levels for long periods.
Specification
1. This product shall only be connected to a USB interface of version USB2.0.
2. Adapter:
The plug considered as disconnect device of adapter.
Power supply and ADP (rating):
Input: AC 100V-240V, 50/60 Hz, 1.8A Max
Output: DC 20.0V, 3.25A
Radiation Exposure Statement
For remote control, this device complies with FCC and IC radiation exposure
limits set forth for an uncontrolled environment.
The transmi er must not be placed or operated in conjunction with any other
antenna or transmi er.
For the LED projector, the device meets FCC and IC radiation exposure limits
specified for uncontrolled environments. In the installation and operation of
the device, the distance between the transmi er and a human body should
be at least 20 cm.
Notes:
The 5.150-5.250 GHz frequency range is only for indoor use.
This frequency applies to member states or geographical areas within member states where
restrictions on use or authorization requirements exist.
04