Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PREPARATION FOR CHARGING
… Use charger for charging LEAD-ACID and LiFePO4 batteries only.
Do not use battery charger for other types of batteries, which may burst
and cause injury to persons and damage to property.
… Use only attachments recommended or sold by manufacturer. Use of non-
recommended attachments may result in fire, electric shock, or injury.
… When disconnecting the battery charger, pull by the plug not by the cord.
Pulling on the cord may cause damage to cord or plug.
… To reduce risk of electric shock, unplug charger from outlet before
attempting any maintenance or cleaning.
… NEVER charge a frozen battery. If battery fluid (electrolyte) is frozen, bring
into a warm area to thaw before charging.
… NEVER place charger directly above battery being charged. Gases from
battery will corrode and damage charger.
… NEVER touch the battery clamps together when the charger is energized.
… NEVER crank engine with charger attached to battery.

CHARGER LOCATION

1. Always charge battery in a well ventilated area. NEVER operate in a
closed-in or restricted area without adequate ventilation. WARNING: Risk of
explosive gas.
2. Locate charger as far away from battery as DC charger cable's permit.
3. Do not expose charger to rain or snow.
4. Intended for indoor use only.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2020 Wagan Corporation. All Rights Reserved.
4

Publicité

Table des Matières
loading

Table des Matières