Configuration Menu; Lipo/Liion/Life Program - ANSMANN Racing xBase 2.0 SE Mode D'emploi

6. Configuration Menu

7. LiPo/LiIon/LiFe Program

When you connect the lithium battery to the balance socket, it will
use the balance charge mode automatically. If you do not connect
it to the balance socket, then it will use the LiPo/Lilon/LiFe charge
mode. You can change the LiPo/Lilon/LiFe charge mode into the
balance charge mode, but cannot change the balance charge mode
into LiPo/Lilon/LiFe charge mode.
4
When balance charging, the built-in balancer can monitor the
individual cell voltage of the battery pack and then balance the
voltage. We suggest you to use the balance charge mode, when
charging 2 – 4 series lithium batteries.
Press the "Enter" key to get into the parameter set mode. When you
are willing to alter the parameter value in the program, press the
"Enter" key to make it blink, then change the value with
"INC/DEC" keys. The value will be stored by pressing the "Enter"
key once. Then press the "Enter" key for more than 2 seconds to
start the process.
This shows the number of cells you set up and the processor
detects."R" shows the number of cells found by the charger and
„S" is the number of cells selected by you at the previous menu.If
both numbers are identical you can start charging by pressing the
"Start/Enter" button. If they are not identical, press the "Mode/
Esc" button to go back to the previous menu, then carefully check
the number of cells of the battery pack to charge again.
This shows the present situation during charge process. To stop the
charging press the "Mode/Esc" key once.
① Battery type
② Cell count
③ Elapsed time
④ Charge current
⑤ Voltage of the battery pack
⑥ Capacity
Instruction Manual