Publicité
OFF
305034
Procedure
1) Remove the top cowling.
2) Remove the flywheel cover by remov-
3) Prepare the engine for starting. See
208022
NOTE:
8 In this case, choke switch will not oper-
ate. Pull out the choke knob when
engine is cold.
ON START
8 Without setting the main switch to
"ON", it is impossible to start the
engine.
701024
4) To start the engine with the emer-
w
208016
Do not install the top cowling when
engine is running.
5-8
ing the bolts.
"STARTING ENGINE" for procedures.
Be sure the engine is in Neutral and
that the lanyard is attached to the
engine stop switch. The main switch
must be on.
gency starter rope, insert the knotted
end of the rope into the notch in the
flywheel rotor and wind the rope sev-
eral turns clockwise. Then, give a
strong pull straight out to crank the
engine. Repeat if necessary.
GB
Publicité
Chapitres
Dépannage
