Ultratech 0E-RCKMT700 Manuel De L'utilisateur page 3

Les langues disponibles

INSTALLING YOUR UPS SYSTEM

UNPACKING

Inspect the UPS upon receipt. The box should contain the following:

(a) UPS unit (b) User's manual (c) Rack mount brackets (d) USB A+B type cable

OVERVIEW

The 0E-RCKMT700 provides automatic voltage regulation for inconsistent utility power. The

0E-RCKMT700 features 1050 Joules of surge protection and provides battery backup during power

outages. The 0E-RCKMT700 ensures consistent power to your equipment during a utility power

loss.

HOW TO DETERMINE THE POWER REQUIREMENTS OF YOUR EQUIPMENT

Ensure that the equipment plugged into the UPS does not exceed the UPS unit's rated

capacity. If the rated capacities of the unit are exceeded, an overload condition may occur

and cause the UPS unit to shut down or the circuit breaker to trip.

There are many factors that can affect the amount of power that your electronic equipment

will require. For optimal system performance keep the load below 80% of the unit's rated

capacity.

AUTOMATIC VOLTAGE REGULATOR

The 0E-RCKMT700 stabilizes inconsistent utility power. The incoming utility power may be

damaging to important data files, but with Automatic Voltage Regulation, the computer will not

experience damaging voltage levels. An Automatic Voltage Regulator automatically increases low

voltage to a consistent, computer safe 110volts/120volts. The unit's powerful sealed lead- acid

batteries will provide power only if the incoming voltage drops below 90 volts or increases above

140 volts.

HARDWARE INSTALLATION GUIDE

Your new UPS may be used immediately upon receipt. However, after receiving a new UPS,

to ensure the battery's maximum charge capacity, it is recommended that you charge the

battery for at least 8 hours. Your UPS is equipped with an auto-charge feature. When the

UPS is plugged into an AC outlet, the battery will automatically charge whether the UPS is

turned on or turned off.

If using the software, connect USB cable to the USB port on the UPS.

With the UPS unit turned off and unplugged, connect your computer, monitor, and any other

peripherals requiring battery backup into the battery power supplied outlets. Plug the other

peripheral equipment (e.g., printer, scanner, speakers, etc.) into the full-time surge protection

outlets. DO NOT plug a laser printer, paper shredder, copier, space heater, vacuum cleaner,

sump pump, or other large electrical device into the "Battery and Surge Protected Outlets".

The power demands of these devices will overload and possibly damage the unit.