HOMCOM 853-009 Mode D'emploi page 6

⑧ Put the water tank on the main body as shown in Figure 9.
⑨ Rotate the switch once and the indicator is on, meaning that the machine is operating
properly. After 43 seconds, the vapor hose nozzle erupts steam, which can be used to
iron clothes, as shown in Figure 10.
1-3. How to Iron
a) Grab a garment with your hand at its lower part, and put it downward. Note: Make the
garment surface level as much as possible.
b) Press down gently, and then drag the nozzle up and down to utilize high-temperature
vapor to soften the fiber before shaping by tension.
c) When ironing the lowest part of the garment, grab the garment on both sides and
strain. Carry out pressing up and down, left and right. Watch out for the hot vapor at
the vapor nozzle.
d) When ironing the collar, press down forcibly a little bit. The vapor nozzle needs to
press the collar edgefold a little longer to enhance up and down pressing.
e) When ironing the sleeves, pull the sleeves straight forcibly a little bit. The vapor nozzle
needs to press the sleeve edgefolds a little longer for pressing back and forth.
f) Iron the front and then the back.
g) Power off after ironing.
IV. Cleaning and Storing
Usual Cleaning and Storing
1. Power off and pull out the power cord.
2. Wait till the machine cools down completely (at least 30 minutes required).
3. Take out the water tank, screw the water tank open. Pour out the water in the water
tank, resin the water tank with clean water, and then eliminate all the water. Put the
water tank back to the sink.
4. Turn over the water tank and unscrew the drainage (for boiler cleaning) knob at the
main body bottom. Lay the water in the main body flat, and then screw the drainage
(for boiler cleaning) knob.
5. Put this machine at a dry position.
Figure 6
Figure 9
Figure 7
5
Figure 8
Figure 10