Assembling The Heater - Qlima GFA 1010 Manuel D'utilisation

• Always use a suitable and approved 700

ASSEMBLING THE HEATER

The manufacturer is not responsible for any harm or damage if attention is not
paid to the points described above.
The use of this product and the elements required for that purpose is entirely at
the end user's own risk.
GFA1015 BAFFLE INSTALLATION INTRODUCTION
To protect your floor ALWAYS mount the baffle to the front outlet of the heater.
1.
2.
3.
4.
Baffle
5.
4
38
Always store the gas containers in a cool,
dry and dark place.
mbar medium-pressure regulator. In case
of any doubt contact your local dealer.
Take out of the heater from the box. The baffle is installed under the air-out-
put as below arrow part
Anti-clockwise unscrew the 2 screws for the baffle.
Install the baffle as below picture.
Clockwise tighten the 2 screws.
Finished status