WERKU WK403240 Manuel D'instructions page 5

ENG ORIGINAL INSTRUCTIONS
faults or accidents. Keep your hands away from all
moving parts of this power too.
AFTER OPERATION.
Do not touch the possible accessories installed in
this power too after use. It may be hot and cause
burns. Some materials worked with may contain
chemicals or toxic components. Avoid inhaling
these substances or allowing them to come into
contact with your skin. Use PPE designed to pre-
vent and protect against incidents of this kind.
PRODUCT DESCRIPTION.
The mixer has been designed to carry out mixing
jobs. Refer to this plan to familiarize yourself with
the mixer before use.
C
D
A. Switch.
B. Lock button.
C. Speed control.
D. HEX13 spindle.
E. Gear selector.
F. Stirrer.
USE INSTRUCTIONS.
Before starting up the mixer, we recommend that
you carefully read all of the instructions as indica-
ted. Please respect all regulations regarding the
prevention of accidents, health and safety directi-
ves, laws and applicable restrictions for work pla-
ces. The mixer must only be used by persons who
have been instructed in its use and only for the
purposes for which it has been designed.
POWER SUPPLY.
Make sure the power supply is adapted to the re-
quirements shown on the information panel of the
mixer (1). Using the motor at low voltage will make
it operate slowly. This will reduce performance
B
and may cause the motor to overheat.
A
EXTENSION CORD.
If the working area is at some distance from the
E
power supply, use an extension cord of enough
diameter and quality.
MIXER-STIRRER MOUNTING-REMOVING.
Before mounting or removing a mixer-stirrer, first
remove the main plug from the socket. This mi-
xer uses mixer-stirrers with a special system for
quick and easy mounting. Apply a small amount
of grease on the mixer-stirrer shaft. Pull the collar
backward and insert the shaft of the mixer-stirrer
F into the chuck (2). Release the collar. In order to
remove the mixer-stirrer, pull the collar backward
and remove the mixer-stirrer from the chuck (5).
SWITCHING ON AND OFF.
By pressing the switch button the mixer is brought
into operation and stops when this is relieved (3).
CONTINUOS OPERATION.
By pressing the switch and simultaneous the lock
button continuous operation is achieved. By pres-
sing and relieving again the switch the continuous
operation is off (4).
5
English