ADB MIKAPACK 15 Manuel D'utilisation page 8

User interface
Navigation
[Enter] : allows going inside a chosen menu item, and the confirm the selections.
[Escape] : goes always one level up or disables your modification.
[Up] and [Down] : allows to page in the menus and to select the data items. If a change is done
inside the menus an asterix(*) will indicate that you are doing modification(s); when pressed
enter the asterix(*) will disappear and your change(s) are saved.
By starting up the MIKAPACK the software version is shown for a short.
Function to set the dimmer to factory reset and to start Address 1
Press [Enter]; Press [Up] or [Down] until FACTORY DEFAULTS appears
Press [Enter]; CLEAR appears
Press [Up] or [Down] until CLEAR ALL appears
Press [ENTER]; CLEAR CONFIRM appears
Press [ENTER]; = > Your MIKAPACK is back set as it left our factory!!!!
BASIC function to change start Address
Press [Enter]; Press [Up] or [Down] until START ADDRESS appears
Press [Enter]; with [Up] or [Down] you can change the start address
Press [ENTER]; to confirm
Note: If a patch is existing MIKAPACK will asks to delete.
A complete manual is downloadable from our website:
Start Address: 1 to 512
Test Dimmer: steady or blinking with LED
feedback
Chaser: 6 pre-programmed chasers
Patch: selectable per dimmer
Law:

linear rms voltage

linear rms to 120V

fluorescent lighting

square law

TV

BBC

OnOf

Customer-defined law
Preheat: for each individual dimmer
Maximum: for each individual dimmer

3 red LED indicators for the supply phases
(L1 – L2 – L3).

2 green LED indicators for microprocessor
running and presence of DMX signal (Run
and DMX).

6 green LED indicators for the dimmer
channels.

4 control buttons.

2 x 8 character LCD display.

DMX IN on XLR 5 F and DMX OUT on
XRL 5 M connectors.
www.adblighting.com
Memories:16 Memories with fade time.

PLAY

EDIT

RECORD

PRIORIRY
If DMX Fails

KEEP – last DMX values

FADE OUT –

MEMORY – Play memory
Factory Defaults

CLEAR – Factory default without deleting
preferences and Memories

CLEAR MEM – Deleting All Memories

CLEAR ALL – Factory default with deleting
preferences and Memories
Preferences

Custom law

If DMX Fails time

Display on / off

Time fade memories
www.adblighting.com Short Form Manual - Page 6
Issue 1.1