Firmware Upgrade; Audio Setup; Video Setup - DTS Zappiti One 4K HDR Guide De Démarrage Rapide

10
Quick Start Guide

Firmware Upgrade

To access the Firmware upgrade page and update the firmware online or via USB, please press the
BLUE button of the RC. To check the most recent changes, latest firmware versions and get recovery
firmware, please visit our website at: .../firmwares

Audio Setup

The Audio section of the Settings Menu allows you to configure preferences for audio output formats.
To access the audio settings, please go to "Settings/Device/Sound and notification". If you are
using an AV receiver compatible with HDMI and multichannel audio, please set the HDMI output to
"Auto". If your AV receiver is compatible HDMI but not compatible HDR, please connect your Zappiti
to your AV receiver using the S/PDIF output. You can also force it to "RAW" (Bitstream). If your AV
receiver is not compatible with DTS and Dolby Digital, please set the S/PDIF output to LPCM 2Ch.
Force SD Audio: The S/PDIF does not support HD Audio such as DTS-HD or Dolby TrueHD. To
convert HD audio into SD Audio (DTS-HD to DTS or Dolby TrueHD to Dolby Digital), please switch "ON"
the Force SD Audio option located in Settings/Developer options. More info:
zappiti.uservoice.com/knowledgebase
Zappiti back panel
Headphones
Headphones Zappiti RCA Output
For video playback without audio-video sync issue, please choose a
wireless headphones compatible with Apt-X Low Latency technology.

Video Setup

By default, the Zappiti is able to auto adjust the video output. But you can manually select the resolution
and frequency of the GUI. To force the output resolution, please switch "ON" the Ignoring HDMI EDID
option located in Settings/Developer options. Then go back to the general settings by pressing the
BACK button of your RC, and go to "Display". You will be able to see all the output modes available
in Manual Settings but the Auto mode will be not available anymore. To adjust the Color Space and the
Deep Color (OFF/10/12-Bit), go to Settings/Developer options. For the best performances, we
advise you the following settings: Y'CbCr 4:4:4 / 10-Bit (if your display is compatible).
Note: the auto framerate is still activated even if you force the HDMI output in a specific
resolution/frequency, however, in some cases, the manual resolution mode can generate some issues.
Please connect one of these cables:
SPDIF Optical (Toshlink) cable
Coaxial cable
To connect wired headphones,
please use RCA to 3.5 mm
female adapter. Then, connect
the RCA connectors to the
RCA inputs of the Zappiti.
Optical In
Coaxial In
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
AV Receiver