Mediclinics M99A-UL Manuel D'installation Et D'utilisation page 2

INTRODUCTION
Technical Features:
• Surface Mounted.
• Sensor Operated - Adjustable Detection Range: 2-6 inches (5-15 cm).
• Voltage: 110 - 120 Volt at 60 Hz.
NOTE: For dryer to function properly, a minimum of 15 inches (40 cm) should be spaced between
the hand dryer sensor and any obstruction such as shelves, hand washing stations, or any type of
reflective surface.
MACHINE SHOULD BE INSTALLED, SERVICED AND MAINTAINED BY A QUALIFIED
INSTALLATION
1. Dismantling for installation
• The dryer is supplied with a pressure-mounted
cover and is not screwed down.
• The 4 attachement screws are provided in the
plastic bag with the plugs and lag bolts.
• Remove cover vertically, taking care
to avoid:
- Damaging internal components.
- Damaging cover (See Figure 1).
2. Mounting
• Mount the machine along the rear channels.
• Insert the electric ducting through the hole next to the terminal strip.
• Use the drill template provided to fix the dryer to the wall.
• Drill 4 holes with a diameter of 5/16" (8 mm), and take care to clean all traces of dust from the
holes.
• Screw down the base firmly to the wall using an screwdriver.
• Connect the electric ducting to the terminal strip. Screw down the 3 locking screws firmly.
• Finally close the terminal block cover properly
.
WARNING: When dismantle the cover, electrical live and basic insulated parts are accesible.
TECHNICIAN
Figure 2
Machine must be handled only by an autorized technician.
-2-
ENGLISH
Figure 1