Publicité
Les langues disponibles
Les langues disponibles
Carburetor adjustment :
The carburetor was pre-set at the factory for optimum performance. If further adjustments are
necessary take your blower to a qualified service dealer.
Spark plug :
▪
To remove spark plug for cleaning or replacement: make sure engine is off, spark plug is
cool, then grasp spark plug boot firmly and remove from spark plug. Remove spark plug with
correct spark plug tool. Inspect, clean or replace as needed.
▪
Spark plug gap = 0.6-.07 mm.
▪
Torque to 105 to 130 inch pounds (12 to 15 Nm). Connect spark plug boot.
Storage :
WARNING: Failure to follow these steps may cause varnish to form in the carburetor
▪
Perform all the general maintenance recommended in the Maintenance Section of your User
Manual.
▪
Clean outside surface of unit.
▪
Drain fuel from the fuel tank.
▪
After fuel is drained, start engine.
NOTE: Never operate the blower without the fuel filter.
Internal engine damage could result!
and difficult starting or permanent damage following storage.
41
Publicité
