Status Of The Lights; Usage; Uhd Transmitter And Uhd Receiver - Marmitek GigaView 911 UHD Guide Utilisateur

4.3 Status of the lights

4. Transmission light (green)
• Lights up continuously: there is a connection between the transmitter and the
receiver and there is an HDMI connection between the two.
• Flashing rapidly:
• There is a connection between the transmitter and the receiver, but no TV
and/or HDMI source is connected and/or enabled.
• The HDMI source does not provide the correct resolution to the transmitter.
Refer to chapter 6.
• Flashing slowly on transmitter: receiver is off
• Flashing slowly on receiver: transmitter is off
• OFF: There is no supply voltage present [3]
5. Power light (blue)
• Lights up continuously: supply voltage is present [3]
• OFF: There is no supply voltage present [3]
When working properly, the transmission light and the power light will both light up
continuously.
5

Usage

5.1 UHD transmitter and UHD receiver

1. Switch ON the TV or projector and select the correct HDMI input to which the
receiver is connected.
2. Switch ON the HDMI source.
3. During system start up, the green transmission light on both the transmitter and
the receiver will flash until the signal connection between the two has been
established.
4. When the connection is established and the HDMI source is properly connected, a
video signal will appear on the TV.
5. When working properly, the transmission light and the power light will both light up
continuously.
6. If no video signal appears, check the lights according to the overview in section
4.3.
HDMI source
6
HDMI
transmitter
HDMI
receiver TV
© MARMITEK