Publicité
Les langues disponibles
Les langues disponibles
5
EN
TROUBLESHOOTING
FR
Where
PL
Cutter broken
CZ
IT
Tool pulling looses
power
Warning lights
flashes
6
WARRANTY CONDITIONS
During the warranty period, the customer must not perform any alterations other than those
permitted by the manufacturer (maintenance). The repairs must be done by an authorized serice
center.
To admit warranty repair, the customer must return the defective tool to the service center of the
manufacturer with the proof of purchase. Warranty is valid only if the tool is in its warranty period
(12 months from the date of purchase confirmed by the proof of purchase) and if the conditions of
use have been respected.
Warranty is not valid if worn spare parts have to be replaced (further to a normal use of the tool).
This product (including battery and charger) shall not be treated as household waste. It shall be
handed over the applicable collection point for the recycling of electrical and electric equipment. By
ensuring this product is disposed of correctly, you will help prevent potential negative consequences
for the environment and human health, which could otherwise be caused by inappropriate waste
handling of this product. The recycling of materials will help to conserve natural ressources. For
more detailed information about recycling of this product, please contact your local city office, your
household waste disposal service or the shop where you purchased the product.
10 •
ELEMENT HEX CUT - User Manual
Cause
Pre-drill hole diameter too small
Puller rod worn off
Chips sticked on cutter
There are metal chips between
cutter and puller rod
Low battery charge or damaged
battery
Tool capacity exceeded
Tool overheating
7
DISPOSAL OF OLD
ELECTRICAL & ELECTRIC
EQUIPMENT
Solution
Pre-drill round hole within specifications
Use new one
Clean and be sure no obvious chips remaining
on cutter before next cutting
Cleaning the cutter set and puller rod
Charge or replace the battery
Let the tool cool down for a moment
Publicité
