Hillyard T30 SC PRO Manuel D'utilisation Et D'entretien page 32

PROBLEM
The vacuum unit is obstructed.
THE SQUEEGEE
DOES NOT DRY
PERFECTLY
The cap on the recovery tank
drainage tube is not properly
positioned.
The recovery tank lid is not
positioned correctly.
The detergent being used is not
EXCESSIVE FOAM
suitable.
PRODUCTION
The floor is not very dirty.
THE MACHINE The recovery tank is full.
DOES NOT
VACUUM
The vacuum device is obstructed
CORRECTLY
POSSIBLE CAUSE
Make sure the squeegee is free of obstructions (read
SQUEEGEE
Make sure the vacuum tube is free of obstructions (see
VACUUM
Make sure the vacuum cap filter is free of obstructions (see
RECOVERY TANK
Make sure the vacuum motor filter is free of obstructions (see
THE RECOVERY TANK
Check that the cap on the recovery tank drainage tube is positioned properly.
Check that the recovery tank lid is properly positioned on the machine.
Check that a low foam detergent has been used. If necessary, add a small
quantity of anti-foam liquid to the recovery tank.
Dilute the detergent more.
Empty the recovery tank (read
Read the section
SOLUTION
BODY").
TUBE").
FILTERS").
FILTERS").
"EMPTYING THE RECOVERY
"THE SQUEEGEE DOES NOT DRY
32
"CLEANING THE
"CLEANING THE
"CLEANING THE
"CLEANING
TANK").
PERFECTLY".