Makita XMT03 Manuel D'instructions page 8

014559
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE:
Forcing or excessive pressure on the tool may
•
reduce efficiency.
Before cutting operation, it is recommended to
•
preset the orbital stroke rate 4 - 6.
Remove sawdust by drawing the tool adequately.
•
It increases work efficiency.
The round saw is recommended for cutting long
•
straight line.
Sanding
CAUTION:
Do not reuse a sanding paper used for sanding
•
metal to sand wood.
Do not use a worn sanding paper or sanding
•
paper without grit.
014560
Apply a sanding paper on the workpiece.
NOTE:
Using a test
•
recommendable to determine a correct orbital
stroke rate suitable for your work.
Use a sanding paper with the same grit until
•
sanding the whole workpiece is completed.
Replacing a sanding paper with different grit
sanding paper may not get a fine finish.
material sample to
Dust extraction attachment
(optional accessory)
1
7
2
1. Nozzle band
2. Dust nozzle
3. Dust attachment
4. Felt ring
5. Pad
6. Holder bolt
7. Holes in the tool
8. Protrusions on the nozzle band
014561
Install dust nozzles and dust attachment.
•
Install the nozzle band on the tool so that its
•
protrusions fit in the holes in the tool to secure it.
Put the felt ring and the sanding pad on the dust
•
attachment and then secure them with the
application tool installation bolt.
try is
014562
When you wish to perform cleaner operation, connect a
vacuum cleaner to your tool. Connect a hose of vacuum
cleaner to the dust extraction attachment (optional
accessory).
8
8
3
4
5
6