FAR R5315WDW/2 Manuel D'utilisation page 18

ENGLISH
INSTALLATION
Position the appliance and allow it to stand for
two to three hours before it is turned on for the
first time to allow the system to settle. Do not
position next to any heat source e.g. cooker, boiler
or in direct sunlight etc.
Allow at least 10 cm of space at the top and
10 cm of space on both sides of the appliance and
between the back of the appliance and the wall
for adequate air circulation. The appliance is not
designed for recessed installation ("building in").
Install on a good firm level surface, and any
unevenness of the floor should be corrected prior
to installation, slight unevenness can be overcome
by adjusting the front feet.
NOTE: If the appliance is positioned on a carpet,
soft floor covering you should readjust the front
feet once the appliance has had time to settle.
GB-8
USE
• This appliance is designed to operate in ambient temperature between
38°C. If these temperatures are exceeded, i.e. colder or warmer, the appliance will
not operate correctly. If the ambient temperatures are exceeded for long periods,
the temperature in the freezer section will rise above -18°C and food spoilage may
occur.
• Remove all packaging materials from the appliance. Wash the inside of the cabinet
with lukewarm water and bicarbonate of soda (5ml to 0.5 liter of water). Dry the
appliance thoroughly.
• When you use the freezer for the first time or after defrosting, set the thermostat
control to the maximum position for at least 2 hours before introducing food to be
stored, and then readjust to the normal position.
• If there is a power failure, do not open the door. Frozen food should not be affected
if the failure lasts for less than hours. If the failure is longer, then the food
19
should be checked and either eaten immediately or cooked and then re-frozen.
SETTING THE THERMOSTAT KNOB
The refrigerator is controlled with a thermostat knob located inside the fridge,
towards the upper right-hand corner. Turn the knob from the STOP (0) position
towards the higher numbers for colder temperatures. The knob can be adjusted from
setting 1 to 7.
Higher settings on the knob (higher numbers) mean lower temperatures (colder) in
all compartments of the appliance.
Changes of the ambient temperature affect temperature in the interior of the
appliance so choose a correct setting of the temperature control knob, depending on
your ambient conditions.
ENGLISH
and
16°C
GB-9