Home Decorators Collection 15614 Instructions D'assemblage page 5

Installation
1
Attaching the leg levelers
□ Provide sufficient protection on the floor to protect the
vanity (A) from damage.
□ Tilt the vanity (A) backwards and remove the shipping feet
from the bottom of the vanity base using a pair of pliers
(not included).
□ Attach each leg leveler (D) by inserting and rotating its
threaded leveler into the holes in the bottom of the vanity
base (A).
3
Securing the vanity to the wall
□ Place the vanity (A) in the desired position taking into
account the location of your plumbing.
□ Ensure the vanity (A) is level front to back and at both
sides.
□ Secure the vanity (A) to the wall by inserting two #8 x 2 in.
screws (not included) through the back rail of the vanity.
CAUTION: It is recommended that the vanity be installed
to at least one wall stud. If you are unable to locate wall
studs, it is recommended that you use wall anchors (not
included) to secure the vanity.
2
Attaching the toe-kick (optional)
□ Place each toe-kick panel (C) underneath the vanity base
(A) bottom shelf, aligning the pre-drilled holes in the toe-
kick panels with the pre-drilled holes in the bottom of the
vanity base shelf.
□ Align each L clamp (H) with the pre-drilled holes on the
vanity base (A) shelf bottom and toe-kick panels (C) and
secure with the CSK screws (G).
D
5
Please contact 1-800-986-3460 for further assistance.
H
C
HOMEDEPOT.COM/HOMEDECORATORS
G