Reverse Door; Energy Saving Tips - Far R5315Wdw Manuel D'utilisation

ENGLISH
ATTENTION
• Only use clean or boiled water that is cold and does not container any impurity.
• Do not use hot water or any carbonated drink such as Cola, Cider etc. (any fizzy
drink).
• Do not remove the water tank from the door to fill.
• The maximum fill must be lower than the tank cover as indicted by the maximum
fill line.
• If water is not dispensing, check the tank is properly located in its holder.
• To remove the tank, make sure that it is empty.
• When using the water dispenser, some water may drip and accumulate in the water
tray at the bottom of the water dispenser. Pull the water tray towards you and clean
it when necessary.
• Mount the seal to water tank per below picture.
ENERGY-SAVING TIPS
Install the fridge or freezer in a cool place out of direct sunlight and away from
cookers, heaters, dishwashers or any hot air emitting items.
Do not set the fridge and freezer temperatures lower than necessary. Set the internal
temperature within the correct range e.g. adjust the thermostat at middle position
for 4°C in the fridge compartment and -18°C in the freezer respectively.
Let pre-cooked foods cool down before placing them in the fridge or freezer.
This will prevent the internal temperature of the fridge from rising.
Keep your fridge full, but not over crowded, this helps reduce "cold" air loss.
Meanwhile, avoid overloading the fridge or freezer. Try to leave about 20% free
space for air circulation.
To prevent cold air escaping, limit the frequency of opening door. When retuning
from shopping, sort foods to be kept in your fridge before opening the door.
Only open the door to put food in or take it out.
Make sure the door seal is clean and in good condition. It should hold a piece of
paper tightly in place when shut.
GB-12
Defrost regularly or when ice is more than 5mm thick. Thick ice covering the inner
sides significantly increases energy use.
The combination of the drawers, baskets and shelves shown in the device description
is optimal for efficient energy savings. Changing the combination proposition could
alter the efficiency.

REVERSE DOOR

Follow the following stages to reverse the door from its initial position.
DEPOSIT DOORS
Take away all hole covers and remove all the cover's screws. Lift the top cover away
1.
from the Fridge.
Remove the left hinge cover. Insert the right hinge cover.
2.
Remove
Unscrew the screws and remove the upper hinge. Deposit the door of the
3.
refrigerating compartment.
ENGLISH
GB-13