Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
LOCATION
Before you install the dryer, select a location with the following characteristics:
•
A hard, level surface. Do not place the dryer on carpeted fl oor.
•
Away from direct sunlight. Direct sunlight may affect the acrylic coating, plastic and electrical
components.
•
Adequate ventilation. Ventilation openings must not be obstructed.
•
Away from sources of heat such as fi replaces or stoves.
•
Make sure that the dryer does not stand on its power cord.
•
There must be at least 10 cm (4 inches) of space between the the dryer and any adjacent wall.
WALL MOUNTING KIT
A wall mounting kit is included with the unit so that the unit can be secured to the wall if necessary.
We recommend using two people to complete the installation as the dryer can be heavy.
The wall mounting kit includes:
Description
Hanging brackets
Plastic spacers
Exhaust connector
12mm long screws
25mm long screws
Tools required:
•
one drill and 3mm bit
•
one Phillips head screwdriver
•
four ɸ12x 50mm timber screws
Note:
•
A minimum of 50mm (2 inches) is required between the top of the dryer and the ceiling.
•
If mounting above a washing machine, ensure there is enough space above the washing machine
to fully open the lid and load or unload the appliance.
•
This dryer is not designed to be placed directly on top of a washing machine or any other
appliance.
Important: If you wish to install the dryer with a stacking kit, we strongly recommend only using
the Danby Dryer with the Danby Laundry Stacking Kit and ensure that you follow all installation
instructions that come with the Laundry Stacking Kit.
Image
Quantity
2
2
1
4
4
5
Publicité
Table des Matières
