Connection Diagrams; Pressure Range00; Range10 - C2AI CPD Série Mode D'emploi

Installation arrangement
Recommended installation arrangement:
vertical, with pressure connections facing downward,
drain of possible condensed water (factory calibration).
Notice: Mount the transmitter with minimum 10 mm distance to
magnetic material. If this is not possible there is a failure of up to
minus 1 Pa for transmitters mounted on sheet steel.
ZP = Push Zero point reset.
The installation position is variable
by using the zero point reset button.
Pressure variations are resettable
after installation.
Ensure the power supply is not
interrupted when storing customer settings (ZP – reset,).

Connection diagrams

2 wire 3 wire
18
C2Ai | www.c2ai.com | tél : 04 72 15 88 70 - CPD - Edition 02/2017 - 120354
ZP
Universal Universal
2 and 3 wire 2 and 3 wire
Version with measurement configuration only
(Adjustability 1)
2
1
3
4
Pressure range
1)
Range00
Range01

Range10

customer adjustment
1) Pressure range
2) Customized factory adjustment
DIP-Switch position according to factory adjustment (see inside cover)
3)
C2Ai | www.c2ai.com | tél : 04 72 15 88 70 - CPD - Edition 02/2017 - 120354
1. DIP-Switch (dual)
2. Zero point reset
3. Connecting terminals
4. Pressure connectors
P1 and P2
2)
3)
1
0
19