Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
You can find more help from our award-winning customer support at Linksys.com/support/E8450.
Your router was not successfully set up
If you could not complete setup in the browser-based interface, you can try the following:
•
Press and hold the Reset button on your router with a paperclip or pin until the power light
on the front of the router turns off and starts blinking (about 10 seconds). Type
192.168.1.1 in a browser to try setup again.
If you are using a modem-router (gateway) and the modem-router is using the IP address
•
192.168.1.x, you might need to enter the IP address 10.0.1.1.
—
Note
If none of those options take you to the setup wizard, go to
www.linksys.com/support/setupIP for more help.
•
Temporarily disable your computer's firewall (see the security software's instructions for
help). Install the router again.
•
If you have another computer, use that computer to install the router.
17
Publicité
