Lenovo SMART CLOCK ESSENTIAL Manuel D'utilisation page 18

Modifying an alarm clock
. 1 Short press the alarm setup button to select an existing alarm.
2 . Press and hold the alarm setup button for more than 2 seconds to enter the alarm
clock setting mode. The day LEDs will start blinking.
— P ress the alarm setup button to confirm the current setting before switching to the
next category.
— P ress the volume up/down buttons to set routine, hours and minutes.
Deleting an alarm clock
In the alarm check interface, short press the alarm setup button and volume down button.
Exiting from alarm clock setting
• Perform no operation for at least 8 seconds.
• Press and hold the alarm setup button for more than 2 seconds.
Snoozing and stopping alarm clock
After an alarm sounds, you can tap or press any button (except alarm setup button) to
enable snooze mode. Your alarm clock will sound again several minutes later (10 minutes
by default).
To stop an alarm clock, short press the alarm setup button or use a voice command.
Sunrise alarm mode
The night light provides a sunrise alarm according to ambient light brightness.
When ambient light is dark, the night light will automatically turn on with gradient
brightness a few minutes before the alarm time.
You can turn off the night light and alarm clock after the alarm sounds.