Cleaning Instructions; Safety Instructions - WIELAND Dental AGC MICROVISION Mode D'emploi

8. Cleaning instructions / 9. Safety instructions

8. Cleaning instructions

Impurities can affect the quality of deposition (e.g. cau-
sing inclusions). For this reason, please clean the entire
electroplating cell thoroughly with distilled water after
each electroforming process. To do this, dismantle the
electroforming cell (consisting of glass beaker, seal, and
electroforming head). Wipe the head parts from time to
time with a damp cloth (do not rinse under running
water).
Wipe the unit occasionally with a damp cloth and dry.
The unit does not require any maintenance. If the unit
should break down in spite of the careful manufacturing
and inspection processes, any repairs must be undertaken
by Wieland Dental + Technik.

9. Safety instructions

When using any electrical appliance, please observe the
following basic safety measures in order to avoid any risk
of electric shock, injury and fire.
Please read and follow these instructions before using
the unit.
9.1. Keep your workplace tidy.
I
9.2. Think about the surrounding conditions.
I
9.3. Keep out of reach of children.
I
9.4. Inspect the unit regularly for damage.
I
I
An untidy workplace can cause accidents.
Do not use the unit in wet or humid conditions
and ensure good illumination. On no account
should liquids get inside the unit.
Do not allow children to play with the unit,
the accessories or the mains cable.
To guarantee that the unit works properly, all the
parts must be assembled correctly and all
conditions observed.
Check the safety devices carefully before use to
ensure they are working properly.
29