Dos/Windows 3.1 Installation - LG CRN-8240E Mode D'emploi

I DOS/Windows 3.1 Installation
For use in DOS/Windows 3.1, your computer must have the Card and Socket Service
software installed first.
The Card and Socket Service software package should come with your notebook
computer or desktop PC card reader, such as SystemSoft, CardSoft, Card Wizard,
Phoenix Technology, IBM ez-play, DataBook, or Award Software. They must be
PCMCIA specification 2.1 compliant or better. Talk to your computer supplier for the
software package.
Following is a two-step guide. It will help you through the installation process and solve
possible system conflicts. Please read it carefully and follow the guide step by step.
Step 1: Install PCMCIA System Software
Your PCMCIA software may come pre-installed in the factory. If it doesn't, please find
the original diskettes and follow the installation procedure to setup the software.
Step 2: Install ATA/ATAPI drivers
Please find the installation diskette shipped with your card, put that disk in drive A and
type
For CD-ROM unit installation:
CD-ROM drivers installation is very straightforward. Basically, it does three things.
1. Copy all necessary files to destination directory (default C:\COMMUTER)
2. Backup and modify CONFIG.SYS file, adding
DEVICEHIGH = C:\COMMUTER\PATAPICD.SYS lines to the file.
3. Backup and modify AUTOEXEC.BAT file, adding
C:\DOS\MSCDEX.EXE line to the file.
Special Note : The DOS/Windows installation is now complete. Reboot your system.
We will go to next step to test the system.
A:\install
E-20