Bell'O AVSC-2123 Instructions D'assemblage page 4

English
NOTE: 2 PEOPLE ARE RECOMMENDED TO
ASSEMBLE THIS FURNITURE. TO AVOID DAMAGE
ASSEMBLE ON A SOFT SURFACE.
1. PLACE the CMS ® (Cable Management System)
(E) onto the Bottom Shelf Support (B) and
SECURE with four 10mm screws (2). DO NOT
FULLY TIGHTEN.
2. TILT the unit so the rear of the CMS
the floor. With the wood facing forward, SECURE
the Left and Right Front Frame Supports (C & D) to
the Bottom Shelf Support from underneath using
50mm Bolts (1). DO NOT TIGHTEN FULLY.
3. TILT the unit upright and ATTACH the Top Shelf
Support (A). SECURE the Top Shelf Support to the
Front Frame Supports using four 50mm Bolts.
SECURE to the Cable Management System
four 10mm Frame Screws (2).
4. Once all parts are correctly fastened together, go
back and TIGHTEN all screws completely.
5. APPLY the four Plastic End Caps (3) to the ends of
each Front Frame Support (C & D).
6. APPLY four Glass Pads (4) where indicated in
Fig. 2 to the Bottom Shelf Support (B). APPLY two
Glass Pads onto the Plastic End Caps at the tops of
the Front Frame Supports.
7. MOVE assembled frame to the location of its
intended use.
8. PLACE the Top Glass Shelf (F) onto the frame, with
the curved edge of the Shelf facing the front, and
PLACE the two silver disks into the holes at the top
of the CMS ® (E). SECURE the Top Glass Shelf
using two 13mm Top Shelf Screws (7). DO NOT
OVERTIGHTEN.
9. PLACE the three Lower Glass Shelves (G) into the
shelf slots on the Front Frame Supports, and into
the slots in the CMS ® .
10. SECURE each Lower Shelf applying four Plastic
Shelf Screws (6) from the underside of each slot
on the Front Frame Supports, and TIGHTEN using
the supplied Screwdriver Tool (8). DO NOT OVER-
TIGHTEN.
11. From the rear of the CMS ® , APPLY the three Shelf
Lock Pins (5) to back of the Lower Glass Shelves.
® is lying on
® with
G
1
Fig. 1
C
1
Fig. 2
4
3
Fig. 3
A
D
E
2
B
4
3
4
3
5
F
7
6