Uninstalling The Cover And Receiver; Jura Contact Details / Legal Information; Led Behaviours / Troubleshooting - Jura Cool Control Wireless 0.6 L Mode D'emploi

4 Uninstalling the cover and receiver

E If the cover has not been used for a long
period of time, clean the milk level sensor
thoroughly with a damp cloth and a mild
liquid detergent before using it again.
You will find information about cleaning the
stainless steel container, adapter and metal pipe in
the Cool Control instructions for use.
4 Uninstalling the cover and
receiver
T Switch off your coffee machine.
T Remove the receiver from the service socket
of the coffee machine.
T Switch off the Cool Control.
5 LED behaviours /
troubleshooting
LEDs in the cover and receiver:
Behaviour Description
LED does not The cover is not supplied with
light up. electricity. The Cool Control is
switched off.
LED lights up. The wireless connection between
the cover and receiver is
established.
LED flashes Attempting to establish the
(once per wireless connection.
second)
Rectifying potential faults:
U
'Error Milk' is displayed, both LEDs light up.
U
The milk level sensor is defective. Service
required.
8
U
Both LEDs flash.
U
The connection between the cover and
receiver is faulty or not established. Press
both Reset buttons at the same time
(e.g. with a pen). As soon as both LEDs
continuously light up blue, the milk level
sensor and the receiver are ready for use.
Problem persisting? Service required.
E If service is required, uninstall the cover and
receiver as described in section 4. Take the
cover and receiver to your JURA dealer.
6 JURA contact details /
legal information
JURA Elektroapparate AG
Kaffeeweltstrasse 10
CH-4626 Niederbuchsiten
Tel. +41 (0)62 38 98 233
@
You will find additional contact details for
your country at www.jura.com.
Technical changes
We reserve the right to make technical changes.
The diagrams used in these instructions for use are
for illustration purposes only and do not represent
the original colours of the machine. Some details
of your machine may vary.
Conformity symbol
A
CE0051
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two condi-
tions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.