Leg Installation; Power Connection - Nidec SHIMPO RK-3E Mode D'emploi

Foot Pedal Installation
Please unplug powercable before starting
① Insert the female connector to the male connector
after positioned correctly.
male connector
② Fasten the connecter by turnning the screw cap.
① Insert the connector

Leg Installation

① Place the wheel vertically on
the carpet as displayed in the
picture to the right.
② Remove the rubber caps.
(keep those for future use.)
Caution: Wheel is
not stable standing
vertically.
③ Insert the leg as the drawing illustrates.
Adjust the height evenly on all three legs. Tighten
bolts with allen wrench.
position of bolts
Bolts
M6 x 12
5 different height adjustments .
Height 290 ㎜
Height 465 ㎜
Height 495 ㎜
Height 525 ㎜
Height 555 ㎜
④ Place the wheel horizontally after tighting the bolts.
female connector
② Turn the screw cap
allen wrench
Splash Pan Installation
① Insert splash pan A into the groove under
the seal frange.
② Insert splash pan B into the groove
under the seal frange.
③ Join splash pan A into splash B
Splash pan Ａ
Wheelhead

Power connection

Power connection
Connect the power cable to a 230v
single phase AC power outlet only.
Do not connect many power
cables to the same outlet.
Make sure the power switch is
off when you plug the power
cable into the AC outlet.
- 5 -
Seal frange
Splash pan B
Splash pan Ａ
Splash pan Ｂ
May cause fi re by
exceeding outlet
capacity.