Day/Night Setting; System Settings; Specifications - Blaupunkt CLX 01 Mode D'emploi

Press the MENU button to store the set
value and to switch to the next menu
item.
If none of the monitor buttons are
pressed for approx. 8 seconds, the
menu is closed and all the set values
are stored.
Settings in TravelPilot mode
➮
On the CCU01, switch to
TravelPilot. The settings are
changed in the same way as in
video mode.

Day/night setting

If the vehicle lights are turned on, the
monitor's brightness will switch to night
mode. For this feature to work, the
monitor's DIM display connection (Plug
III/Pin 3) must be connected to the + of
terminal 58.
The brightness and contrast picture set-
tings can each be adjusted separately
for day and night and for video mode
and TravelPilot mode. The set values
are stored when the menu is closed.

System settings

➮
Keep pressing the MENU button
on the CLX01 until SYSTEM +>>>
appears in the display.
➮
Next, press the
The following appears in the
display
CAM1+CAM2+CAM3
CAMERA SETUP
button.
CONTROLS AND SETTINGS
➮
Press the
the required camera configuration.
Note:
Only the selected cameras can be
switched on.
To select the reversing camera
➮
press the MENU button to access
REAR VIEW CAMERA mode.
➮
Press the
INVERTED, if you want to display
a mirror image of the reversing
camera signal or
NORMAL for a non-mirror image.
When you close the menu, any changes
that you made to the settings will be
stored.

Specifications

Operating voltage:
Closed-circuit current: 30 mA
Stand-by current:
Output voltage
for cameras:
Subject to changes!
or button to select
or button to select
12 V - 24 V
< 1 mA
12 V / 200 mA
11