Kin HNB 400 Auto A Mode D'emploi page 5

HNB 400 Auto A
GB
The manufacturer refuses to undertake any responsibility for any error
which might appear in this manual due to misprint or misreplication. The
manufacturer reserves the right to make any modification to the product,
which, in its opinion, is necessary or useful, without affecting basic features
of the product.
The pump must be connected with a current type leakage current breaker
which carry a rated leakage current of no more than 30 MA.
Check the connection of the plug before running. If the wire is damaged, it
must be replaced by the manufacturer, the agent or the relevant technical
personnel to avoid any danger.
Liquid contamination may be caused by leakage of lubricat-ing oil.
Do not use pumps when there is someone in the water.
When cleaning and maintaining, please disconnect the water pump from
the main power supply.
Connectors for power plugs and extension cables must be made sure that
they are watertight and must not be placed in the water. Furthermore,
connectors cannot be placed on the ground. It is recommended to ensure
that the outlet is at least 60 mm from the ground.
5
kinpumps.com