REV Ritter MAX! Fensterkontakt Mode D'emploi page 16

• The magnet (1) can be installed on either
side of the electronic unit (2). Installation
must be in parallel with a maximum
spacing of 8 mm (A).
• The window sensor can be attached both
vertically and horizontally.
• The magnet (1) must be centre-aligned with
the electronic unit (2) (C).
• The magnet (1) and electronic unit (2)
must be attached at the same level or
as close to the same level as is possible
within the space (B). You might need
to use the spacers supplied for the
magnets (1) to do this.
Each of the elements can be fastened in two ways:
Adhesive strip method:
The surface must be clean and dry.
Using adhesive strips does not damage the door or
window in any way.
• Stick the adhesive strips supplied
with the device on the rear sides
of the brackets (1 and 2).
• Then press the brackets onto the
frame and window.
16