Ferroli DIAMANT 7 Manuel D'utilisation page 25

DIAMANT
Proceed as follows:
1.
Position the plate on the wall at a suitable height and fix it in place keeping it as level as possible (use a spirit level).
2. Mark the position of the securing holes.
3. Using a drill and Ø5 mm bit, drill the holes for securing the unit and insert the expansion plugs.
4. Choose the outlet side of the connection pipes. It is advisable to use the rear right-hand outlet but if this is not possible, see the
"INSTALLATION OPTION" a pagina 26 section.
5. Drill a Ø65 mm hole (or Ø90 mm depending on the model) in the wall ("fig. 11 -")), slightly sloping downwards towards the outer
part, starting to drill from one side of the wall (A) and ending with the opposite side (B) to prevent the actual wall from breaking.
6. Fix the plate to the four holes drilled previously using the relative screws.
7.
Carefully lift and turn the pipe sections required to connect the outdoor unit and pass them through the 70 mm hole.
8. Pass the condensation drain pipe through the same hole. Depending on the specific requirements, this pipe may be conveyed
also in other directions provided that it slopes sufficiently to allow the condensation to flow down (refer to the section ""INDOOR
UNIT CONDENSATION DRAIN CONNECTION" a pagina 27 of the present manual).
9. Hang the indoor unit securely on the hooks of the securing plate.
10. Make sure that it is firmly secured by moving the unit to the right and left.
Interior A
Note: To make the unit easier to fix to the plate, hold the bottom part of the unit up and lower it in a perpendicular position accom-
"fig. 12 -"
panying the sheath. (
External B
fig. 11 -
). The installer must perform all the operations according to specific requirements.
Cod. 3QE46120 - Rev. 00 - 11/2019
fig. 12 -
EN
25