Technical Specifications - Perel WPST1 Mode D'emploi

• [B] Mount the fixed part [9] of the clamping assembly on the base [10] with 2 hex bolts,
washers and nuts. Mount in the longer of the 2 grooves.
• [B] Mount the clamping part [8] of the clamping assembly in the shorter groove. Use the
M8x35mm bolt and the square nut.
• [B] Place the clamping lever [7] over the bolt, small hole aligned with the threaded hole and
insert a bolt M6x14mm.
• [C] Mount the protection guard [6] on the base [10] using an M6x14mm bolt and nut.
7. Use
• Inspect the grinder stand for signs of damage before every use. When damage is noticed, do
not use it. Contact your local dealer for repair and/or spare parts.
• Keep the working area clean at all times.
• Place the grinder stand on a flat and steady surface capable of carrying the weight of the stand
and the work piece. Do not use on slopes etc. ...
• For security reasons, it is highly recommended to attach the grinder stand to the work bench.
Screw 4 screws (not incl.) through the 4 corners of the base [10].
• Remove the handle from a suitable grinder (not incl., size 115/125mm) and place it in the grinder
holder [3].
• Use the appropriate bolts and nuts [4] or [5] to hold the grinder in place. Apply bolts on both
sides of the grinder.
• Position the lateral supports [2] in such a way that the grinder is securely fixed and can not
move inside the holder [3].
• Place the work piece on the base [10] against the fixed part [9] of the clamping assembly. When
necessary, reposition the latter.
• [D] Slide the clamping part [8] of the clamping assembly against the work piece and move the
clamping lever [7] clockwise to clamp the work piece.
• Switch on the grinder.
• [D] When the grinder is at full speed, gently pull down the lever [1].
• When finished, gently lift the lever [1].
• Switch off the grinder and wait until the grinding disc comes to a full stop before handling the
work piece.

8. Technical specifications

dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.perel.eu. The information in this
manual is subject to change without prior notice.
31/08/2010
base
height
WPST1
245 x 245mm
±280mm
2035g
4
®
© Velleman nv