Publicité
Les langues disponibles
Les langues disponibles
8
Assembly Instructions (continued)
9
IMPORTANT BEFORE USE
HOW TO SEASON LAVA ROCK
1 . Place the lava rocks into the fire pit bowl before turning on .
2 . Follow the lighting instructions from the owner's manual to light the fire pit .
3 . Turn the fire pit to the highest heat .
4 . Allow the lava rocks to heat at the maximum temperature for 30 minutes
1111before enjoying fire pit .
5 . Keep all people and any material that could burn at least 15 feet away from the
1111fire pit while the lava rocks are being seasoned .
6 . Repeat the process if your fire pit has been exposed to rain or moisture .
7 . Keep your fire pit covered when not in use .
OPTIONAL ITEM SOLD SEPARATELY
10
Place Lava Rocks - Wear protective gloves
W CAUTION: When switching from fire glass, remove all fire
glass before placing lava rock.
W CAUTION: Do NOT dump lava rocks out of package. Carefully
place lava rocks by hand so dust does not clog burner.
W CAUTION: Wear protective gloves.
W CAUTION: Use only Mr.Bar-B-Q Products LLC. factory-
authorized lava rock. The use of any lava rock that is not
factory-authorized can be dangerous and will void your
warranty.
W CAUTION: Do NOT cover igniter cover.
Note: Lava rocks should be 0 .8-2 .0 in . (2-5 cm) long . Approx . 3 .74 lb (1 .7 kg) of
lava rocks are needed .
LP Gas Outdoor Fire Pit
Model No. GAD17108ES
Installing LP Gas Tank
To operate, you will need one precision-filled standard grill LP gas
tank with external valve threads .
W CAUTION: LP gas tank must be properly
disconnected and removed prior to moving this
outdoor fire pit.
Inserting LP Gas Tank
W WARNING: Make sure LP gas tank valve is closed.
1 .
Open door .
2 .
Make sure the control knob is in the " OFF" position (Figure 3) .
3 .
Loosen LP gas tank retainer bolt by turning counter-clockwise .
4 .
Place precision-filled LP gas tank upright into hole in outdoor fire pit base so the tank valve
is facing the gas line connection .
5 .
Secure tank by turning LP gas tank retainer bolt clockwise until tight .
6 .
Close door .
Connecting LP Gas Tank
1 .
Make sure the control knob is in the " OFF" position
(Figure 3) .
2 .
Before connecting, be sure there is no debris caught in the
head of the LP gas tank, head of the regulator valve or in the
head of the burner or burner ports .
3 .
Connect regulator/hose assembly to tank by turning knob
clockwise until it stops .
4 .
Perform leak check per "Checking for Leaks" section .
Disconnecting LP Gas Tank
1 .
Make sure the control knob is in the " OFF" position
(Figure 3) .
2 .
Before disconnecting, make sure the LP gas tank valve is
"CLOSED ."
3 .
Disconnect regulator/hose assembly from LP gas tank by
turning knob counterclockwise until it is loose .
W CAUTION: LP gas tank must be properly
disconnected and removed prior to moving
this fire pit.
4 .
Place the protective cap cover on the LP tank and store the tank outdoors in a well
ventilated area out of direct sunlight .
20 lb
9 Kg
12.2 in. / 31 cm
Publicité
