Electrolux LFT769X Manuel D'utilisation page 4

4 www.electrolux.com
exhaust smoke and steam from other appliances (central heating
systems, thermosiphons, water-heaters, etc.).
• When the appliance operates with other appliances the maximum
vacuum generated in the room should not exceed 0.04 mbar.
• Make sure not to cause damage to the mains cable. Contact our
Authorised Service Centre or an electrician to change a damaged
mains cable.
• If the appliance is connected directly to the power supply, the electri-
cal installation must be equipped with an isolating device that allows
to disconnect the appliance from the mains at all poles. Complete
disconnection must comply with conditions speci ed in the overvol-
tage category III. The means for disconnection must be incorporated
in the  xed wiring in accordance with the wiring rules.
• Do not  ambé under the appliance.
• Do not use to exhaust hazardous or explosive materials and vapours.
• Clean the appliance regularly to prevent the deterioration of the
surface material.
• Clean the appliance with a soft cloth regularly.
• Do not use a steam cleaner, water spray, harsh abrasive cleaners
or sharp metal scrapers to clean the surface of the appliance. Use
only neutral detergents.
• Clean grease  lters regularly (at least every 2 months) and remove
grease deposits from the appliance to prevent the risk of  re.
• Use a cloth or brush to clean the interior of the appliance.
2. SAFETY INSTRUCTIONS
2.1 Installation
WARNING!
Risk of injury, electric shock,  re,
burns or damage to the appliance.
• Only a quali ed person must install this
appliance.
• Do not install or use a damaged appliance.
• Follow the installation instructions supplied
with the appliance.
• Always take care when moving the ap-
pliance as it is heavy. Always use safety
gloves and enclosed footwear.
• Before installing the appliance remove
all the packaging, the labelling and the
protective  lm.
• Do not install the exhaust air into a wall
cavity, unless the cavity is designed for
that purpose.
2.2 Electrical connection
WARNING!
Risk of  re and electric shock.
• All electrical connections should be made
by a quali ed electrician.
• Make sure that the parameters on the ra-
ting plate are compatible with the electrical
ratings of the mains power supply.
• If the symbol ( ) is not printed on the ra-
ting plate, the appliance must be earthed.
• Always use a correctly installed hockproof
socket.
• Do not let the electricity mains cable
tangle.