Environmental Information - Philips AJ3380/04 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
– If a fault occurs, first check the points listed below before taking the set for repair.
– If you are unable to remedy a problem by following the hints below, consult your dealer or service
centre.
WARNING:
under no circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
PROBLEM
– Possible cause
• REMEDY
NO SOUND
– Volume not adjusted.
• Adjust the volume.
MW (OR LW) BROADCAST CANNOT BE RECEIVED
PROPERLY
– Weak radio signal.
• Rotate the set for better reception and make
sure the set is placed on a non-metallic
surface.
CONTINUOUS CRACKLING AND HISS NOISE
DURING MW (OR LW) RECEPTION
– Interference from other electrical equipment
e.g. TV's, computers, fluorescent lamps.
• Move the clock radio away from electrical
equipment.
INTERMITTENT CRACKLING SOUND DURING FM
RECEPTION
– Weak signal.
• Adjust the pigtail aerial.
The type-plate is located on the bottom of the clock radio.
This set complies with the radio interference requirements of the European Community.
TROUBLESHOOTING
THE ALARM DOES NOT FUNCTION
– The alarm is not set
• Set the alarm time and the alarm switch to
BUZ
– Volume too low for radio.
• Increase the volume.
THE SLUMBER DOES NOT FUNCTION
– RADIO still in ON position.
• Switch RADIO to OFF position.

ENVIRONMENTAL INFORMATION

All unnecessary packaging material has been
omitted. We have tried to make the packaging
easy to separate into three mono-materials:
cardboard (box), expandable polystyrene (buffer),
polyethylene (bags).
Your set consists of materials which can be
recycled if disassembled by a specialized
company. Please observe the local regulations
regarding the disposal of packing materials,
exhausted batteries and old equipment.
or
.
RAD
7

Publicité

Table des Matières
loading

Table des Matières