Télécharger Imprimer la page

emerio WK-123483.5 Mode D'emploi page 5

Publicité

Les langues disponibles

Les langues disponibles

This water kettle is equipped with an overfill safety feature. This will make sure that in case of overfilling
the kettle the water will not come in contact with electrical components of the kettle ensuring no unsafe
situations can occur. In case of overfill the water will be lead through the inner side of the kettle and will
exit the kettle at the bottom, away from the electrical element.
2.
Close the lid. Position the kettle on the power base in place. Make sure the kettle contacts with the power
base completely.
3.
Connect the plug into a power outlet. Press the switch downwards. The indicator will light up. Then start
to boil the water. The kettle will switch off automatically once the water has boiled. You can shut off the
power by pressing the switch button upwards at any moment during boiling water.
NOTE: Ensure that switch is clear off obstructions and the lid is firmly closed all the time throughout the
boiling cycle. The kettle will not turn off if the switch is constrained and scalding may occur if the lid is
open.
4.
Once the water boils, wait 10 seconds before pouring out water to prevent hot steam from exiting through
the lid of the kettle. Lift the kettle then pour the water.
NOTE: operate carefully when pouring the water from your kettle as boiling water will scald. Do not open
the lid while the water in the kettle is hot.
5.
The kettle will not re-boil until the switch is pressed downwards. Allow to cool for 30~40 seconds before
reopening to boil water. Never re-boil water older than 2 hours. The kettle may be stored on the power
base when not in use.
NOTE: Ensure power supply is turned off when kettle is not in use.
6.
Should you accidentally allow the kettle to operate without water; the boil-dry protection will
automatically switch it off. If this occurs, allow the kettle to cool before filling with cold water and
re-boiling.
CLEANING AND MAINTENANCE
1.
Always let the kettle cool down first and disconnect the appliance from the power outlet before cleaning.
2.
Never immerse the kettle area or cord in water, or allow moisture to contact with these parts.
3.
To clean the filter: unlock the lid and pull out the filter. Rinse the filter with running water and then dry it.
Cleaning appearance of housing:
Wipe the appearance of body with a mild and damp cloth or cleaner, never use a poisonous cleaner.
Never immerse the power base in water or other liquid for cleaning.
Descale regularly, preferably at least once a month and more frequently if your water is very hard.
To descale your kettle, use:
• white vinegar
- fill the kettle with half a litre of vinegar
- leave to stand for 1 hour without heating
• citric acid:
- boil half a litre of water
- add 25g of citric acid and leave to stand for 15 minutes.
Empty your kettle and rinse it 5 or 6 times.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50-60Hz
Power consumption: 1850-2200W
- 4 -

Publicité

loading