Publicité
Les langues disponibles
Les langues disponibles
GEM, MIRRORED AND CRUSHED GLASS MEDIA PLACEMENT
A.
Carefully inspect the carton for shipping damage. If any parts are missing or damaged, call your dealer.
Do not attempt to install the appliance unless all parts are in good condition.
B.
Correct installation is crucial to safe performance of your Outdoor Fire Pit.
C.
CAUTION:
Due to high temperatures, the Fire Pit must be located out of traffic areas and away from combustibles
GEM, MIRRORED AND CRUSHED GLASS MEDIA PLACEMENT
Pour the first bag of the glass media into
the burner support.
Figure 1.
Place the largest log diagonally
centered over the burner.
CAUTION:
BURN HAZARD. GEM, MIRRORED and CRUSHED GLASS and LAVA GRANULES
YOU MUST MAINTAIN THE LAYOUT AS SHOWN TO ENSURE PROPER OPERATION OF YOUR FIRE PIT.
IF YOU NEED TO REPOSITION ANY MATERIAL TO MAINTAIN THE PROPER LAYOUT, USE HEAT
RESISTANT GLOVES OR ALLOW MATERIAL ADEQUATE TIME TO COOL BEFORE HANDLING.
CAUTION:
Lava granules used in a fire pit are porous and when heated up to normal operating temperature
can cause trapped gasses or moisture to expand and cause a "pop" and "launch" outside of the fire pit, which
could cause injury or property damage. Allow lava granules to completely dry after getting
Pour the glass gem / crushed glass media into the
Outdoor Fire Pit so that the burner is completely covered.
(See Figure 1 and 2
Figure 1.
CERAMIC LOG MEDIA PLACEMENT
Pour the lava granules into the Outdoor Fire Pit so that the burner
is completely covers the burner by 1/2" and spread evenly.
(See Figure 1, 2 and 3)
Place the larger three logs as
desired using the largest log as the
WILL REMAIN HOT FOR SOME TIME AFTER USE.
hosed off, before lighting and using the fire pit.
Pour the additional bags of media onto
the burner support. Spread the media
evenly covering the burner.
Figure 2.
support.
Page 8
Figure 2.
Figure 3.
Place the balance of the logs as
desired. Make sure to leave enough
air flow.
wet,
rained on or
Publicité
